R2511-HP MSR Router Series Interface Command Reference(V5)

38
virtual-cable-test
Use virtual-cable-test to test the cable connection of an Ethernet interface. The test results are displayed
within 5 seconds.
Syntax
virtual-cable-test
Views
Layer 2 Ethernet interface view
Default command level
2: System level
Usage guidelines
The following matrix shows the command and router compatibility:
Command MSR900 MSR93X MSR20-1X MSR20 MSR30 MSR50 MSR1000
virtual-cabl
e-test
Available
only on
fixed
Layer 2
Ethernet
interfaces
No
Available
only on
fixed Layer
2 Ethernet
interfaces
Available
only on
fixed
Layer 2
Ethernet
interfaces
Available
only on
MSR30-10
router
installed
with
XMIM-FS
W
modules
and MSR
routers
with
SIC-4FSW
and
DSIC-9FS
W
modules
installed
(the port
numbered
9 of a
DSIC-9FS
W module
does not
support
this
command)
No No
The following cable states are available:
• Normal—The cable is in good condition.
• Abnormal—Any fault other than a short or open circuit is detected.
• Abnormal (open)—An open circuit is detected.
• Abnormal (short)—A short circuit is detected.
• Failure—The detection failed.