R2511-HP MSR Router Series Interface Configuration Guide(V5)

21
Ste
p
Command Remarks
7. Set the MTU.
mtu size
Optional.
The default is 1500 bytes.
8. Set the polling interval.
timer hold seconds
Optional.
The default is 10 seconds.
9. Enable cellular interface
debugging.
dm-port open
Optional.
Disabled by default.
Supported only on SIC-3G
interface modules.
10. Search for public land
mobile networks (PLMNs).
plmn search
The configuration is automatically
saved in a nonvolatile storage
medium of the modem. Use the
display cellular or display
cellular-ethernet command to
verify the configuration.
11. Configure PLMN searching
mode.
plmn select { auto | manual mcc mnc }
Optional.
The default searching mode is
auto.
The configuration is automatically
saved in a nonvolatile storage
medium of the modem. Use the
display cellular or display
cellular-ethernet command to
verify the configuration.
12. Create a parameter
description profile for the
USB 3G or 4G modem.
profile create profile-number
{ dynamic | static apn }
authentication-mode authentication
[ user username ] [ password
password ]
Optional.
By default, this template does not
exist.
Repeat this step to create profiles.
To specify two profiles as the
primary and backup profiles, you
must configure the same username
and password for them.
13. Specify the primary and
backup profiles.
profile main profile-M-number backup
profile-B-number
Optional.
By default, profile 1 is used for 3G
or 4G modem dialup.
For each dialup connection
establishment, the 3G or 4G
modem uses the backup profile
only when it has failed to dial up
using the primary profile.
This command takes effect only on
dialup connections initiated after
the command is configured. It
does not take effect on the dialup
connection that has been
established.
14. Select a CDMA network
connection mode.
mode cdma { 1xrtt-only | evdo-only |
hybrid | lte-only | auto }
Optional.