R2511-HP MSR Router Series Interface Configuration Guide(V5)

26
Step Command Remarks
6. Configure a short message
forwarding rule.
sms forward source-number
source-number destination-number
destination-number
Optional.
After you configure a short
message forwarding rule, the
system automatically forwards the
short message from the specified
source number to the specified
destination number.
Deploying configuration on the device through SMS
If your device has a 3G modem, you can send short messages through the 3G network to deploy initial
settings listed in Table 2 o
n the device. The operation procedure is as follows:
1. The administrator sends a deployment short message in the specified format (started with dpl:) to
the device.
2. After receiving the short message, the device analyzes the short message content and completes
the configuration.
3. The router sends a reply short message (started with rsp:) to the sender to report the deployment
result.
The SIC-4G-LTE modem module does not support deploying configuration on the device through SMS.
To configure the SMS-based configuration deployment feature:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enable the SMS method of
configuration deployment.
autodeploy sms enable By default, this function is enabled.
3. Enable the device to send the
content of incoming short
messages in SNMP traps.
snmp-agent trap enable sms
Optional.
By default, this function is enabled.
4. Enter cellular interface view.
interface cellular interface-number
N/A
5. Specify PPP or Ethernet
encapsulation on the 3G
modem module.
card-mode slot slot-num { ppp |
ethernet }
N/A
6. Enter interface view.
• Enter cellular interface view:
interface cellular
interface-number
• Enter cellular Ethernet interface
view:
interface cellular-ethernet
interface-number
Use the interface cellular command
if PPP encapsulation is specified.
Use the interface cellular-ethernet
command if Ethernet encapsulation
is specified.