R2511-HP MSR Router Series Interface Configuration Guide(V5)

27
Step Command Remarks
7. Enable SMS on the interface.
sms sending-enable
Optional.
By default, SMS is disabled on
cellular interfaces. The device
cannot send any short messages
except configuration deployment
responses and forwarded short
messages.
Table 2 Parameter template description
Parameter Description
dpl: Deployment SMS identifier.
pu:
PPP authentication username for which both CHAP authentication and PAP
authentication can be configured.
For more information, see Layer 2—WAN Configuration Guide.
cu:
PPP authentication username for which only CHAP authentication can be configured.
For more information, see Layer 2—WAN Configuration Guide.
1u:
PPP authentication username for which only PAP authentication can be configured.
For more information, see Layer 2—WAN Configuration Guide.
ps:
PPP authentication password.
For more information, see Layer 2—WAN Configuration Guide.
dn:
PPP dial string.
For more information, see Layer 2—WAN Configuration Guide.
an: 3G access point name, provided by ISP.
ac:
ACS URL.
For more information, see Network Management and Monitoring Configuration Guide.
au:
ACS login username.
For more information, see Network Management and Monitoring Configuration Guide.
as:
ACS login password.
For more information, see Network Management and Monitoring Configuration Guide.
A deployment short message must meet the following text format requirements:
• The message must start with dpl:.
• Separate the parameter name and value with a colon (:).
• Separate two parameters with a line break.
• The content is case sensitive.
• The message must not contain any parameters that are not in Table 2.
• Y
ou can deploy configuration in multiple messages, each of which must start with dpl:.
• The name and value of one parameter must be sent in one message.
• The ps parameter and one of the pu, cu, and lu parameters must be sent in one message.
The following is a sample deployment short message: