R2511-HP MSR Router Series Interface Configuration Guide(V5)

41
Step Command Remarks
4. Bundle timeslots on the
interface into a channel set.
channel-set set-number timeslot-list
list
N/A
5. Enable RAI detection on the
interface.
alarm detect rai
Optional.
Enabled by default.
6. Set other interface
parameters.
See "Configuring other CE1/PRI
interface parameters."
Optional.
A CE1/PRI interface operating in CE1/PRI mode can be used as a CE1 interface where a serial interface
is created upon creation of a channel set. You may bundle timeslots on a CE1/PRI interface into up to 31
channel sets.
For each channel set, the system automatically creates a serial interface numbered serial
interface-number:set-number. This interface is logically equivalent to a synchronous serial interface
where you can make other configurations such as:
• Data link protocol such as PPP, FR, LAPB, or X.25
• IP addressing
• Backup center settings if the interface is used as a primary or secondary interface for backup
• NAT and packet filtering if a firewall is to be set up
NOTE:
The timeslots on a CE1/PRI interface can be bundled into either channel sets or a PRI set, but not the both,
at a time.
Configuring a CE1/PRI interface in PRI mode
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter CE1/PRI interface view.
controller e1 number N/A
3. Configure the interface to
operate in CE1/PRI mode.
using ce1
Optional.
The default operating mode is
CE1/PRI mode.
4. Bundle timeslots on the
interface into a PRI set.
pri-set [ timeslot-list list ]
If no timeslot range is specified, all
timeslots except timeslot 0 form a
30B + D ISDN PRI interface.
5. Set other interface
parameters.
See "Configuring other CE1/PRI
interface parameters."
Optional.
A CE1/PRI interface in CE1/PRI mode can be used as a PRI interface where only one PRI set can be
created.
For the PRI set, the system automatically creates a serial interface numbered serial interface-numbe:15 .
This interface is logically equivalent to an ISDN PRI interface where you can make other configurations
such as:
• DCC
• PPP and PPP authentication