R2511-HP MSR Router Series Interface Configuration Guide(V5)
43
Step Command Remarks
14. Enable user data inversion.
data-coding { inverted | normal }
Optional.
Disabled by default.
15. Set the intended bandwidth
for the CE1/PRI interface.
bandwidth bandwidth-value Optional.
16. Set the physical state change
suppression interval for the
CE1/PRI interface.
link-delay delay-time
Optional.
By default, state change
suppression is disabled.
17. Restore the default settings for
the CE1/PRI interface.
default Optional.
18. Shut down the CE1/PRI
interface.
shutdown
Optional.
Up by default.
19. Return to system view.
quit N/A
20. Enter the view of the
synchronous serial interface
created on the CE1/PRI
interface.
interface serial
interface-number:set-number
or
interface serial
interface-number:15
N/A
21. Set the CRC mode
crc { 16 | 32 | none }
Optional.
By default, 16-bit CRC is adopted.
Configuring error packets diffusion restraint
Error packets diffusion refers to the situation when one timeslot receives a certain error packet. All the
other timeslots are affected, and they also receive error packets.
You can restrain error packet diffusion by configuring three parameters: detect-timer, renew-timer,
threshold, which function in the following way:
If, during the time specified by detect-timer, the ratio of error packets on an interface is greater than that
specified by threshold, the interface is regarded as faulty and is shut down. After waiting for some time
specified by renew-timer, the interface is brought up again.
To configure error packets diffusion restraint:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enable error packets diffusion
restraint.
error-diffusion restraint enable N/A
3. Configure the parameters of
error packets diffusion
restraint.
error-diffusion restraint config
detect-timer renew-timer threshold
Optional.
By default, the value of detect-timer
is 30 seconds, of renew-timer is
600 seconds; the threshold is 20%.
4. Restart the channel that is shut
down for the sake of error
packets restraint.
error-diffusion restraint
restart-channel serial
interface-number:set-number
Optional.