R2511-HP MSR Router Series Interface Configuration Guide(V5)

45
Step Command Remarks
3. Bundle timeslots on the
interface into a channel set.
channel-set set-number timeslot-list
list [ speed { 56k | 64k } ]
Up to 24 channel sets can be
bundled.
The default timeslot speed is 64
kbps.
4. Set other interface
parameters.
See "Configuring other CT1/PRI
interface parameters."
Optional.
For each channel set, the system automatically creates a serial interface numbered serial
number:set-number. This interface is logically equivalent to a synchronous serial interface where you can
make other configurations about:
• Data link protocol such as PPP, FR, LAPB, or X.25
• IP addressing
• Backup center settings if the interface is used as a primary or secondary interface for backup
• NAT and packet filtering if a firewall is to be set up
Configuring a CT1/PRI interface in PRI mode
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter CT1/PRI interface view.
controller t1 number N/A
3. Bundle timeslots on the
interface into a PRI set.
pri-set [ timeslot-list list ]
Only one PRI set can be created at
a time.
4. Set other interface
parameters.
See "Configuring other CT1/PRI
interface parameters."
Optional.
For the PRI set, the system automatically creates a serial interface numbered serial number:23. This
interface is logically equivalent to an ISDN PRI interface where you can make other configurations about:
• DCC
• PPP and PPP authentication
• IP addressing
• Backup center settings if the interface is to be used as a primary or secondary interface for backup
• Firewall, if any
Configuring other CT1/PRI interface parameters
To configure other CT1/PRI interface parameters:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter CT1/PRI interface view.
controller t1 number N/A