R2511-HP MSR Router Series IP Multicast Command Reference(V5)

93
Parameters
interval: Specifies a hello interval in seconds, in the range of 1 to 2147483647.
Examples
# Set the hello interval to 40 seconds on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] pim timer hello 40
Related commands
timer hello
pim timer join-prune
Use pim timer join-prune to configure the interval at which join/prune messages are sent on the current
interface.
Use undo pim timer join-prune to restore the default.
Syntax
pim timer join-prune interval
undo pim timer join-prune
Default
The join/prune interval is 60 seconds.
Views
Interface view
Default command level
2: System level
Parameters
interval: Specifies a join/prune interval in seconds, in the range of 1 to 2,147,483,647.
Examples
# Set the join/prune interval to 80 seconds on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] pim timer join-prune 80
Related commands
timer join-prune
pim triggered-hello-delay
Use pim triggered-hello-delay to configure the maximum delay for sending a hello message.
Use undo pim triggered-hello-delay to restore the default.
Syntax
pim triggered-hello-delay interval