R2511-HP MSR Router Series IP Multicast Command Reference(V5)

107
Examples
# Set the global join/prune interval to 80 seconds on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer join-prune 80
# Set the global join/prune interval to 80 seconds in VPN instance mvpn.
<Sysname> system-view
[Sysname] pim vpn-instance mvpn
[Sysname-pim-mvpn] timer join-prune 80
Related commands
pim timer join-prune
timer spt-switch (PIM view)
Use timer spt-switch to configure the interval between checks of the traffic rate threshold before an SPT
switchover.
Use undo timer spt-switch to restore the default.
Syntax
timer spt-switch interval
undo timer spt-switch
Default
The traffic rate threshold is checked at an interval of 15 seconds before an SPT switchover.
Views
Public network PIM view, VPN instance PIM view
Default command level
2: System level
Parameters
interval: Specifies an interval in seconds between checks of the traffic rate threshold prior to an SPT
switchover. The value range is 15 to 65535.
Usage guidelines
Before using this command, be sure to use the spt-switch-threshold command to configure the traffic rate
threshold that should trigger an SPT switchover. Otherwise, the interval set in this command does not take
effect.
Examples
# On the public network, set the interval between checks of the traffic rate threshold prior to an SPT
switchover to 30 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] timer spt-switch 30
# In VPN instance mvpn, set the interval between checks of the traffic rate threshold prior to an SPT
switchover to 30 seconds.
<Sysname> system-view