R2511-HP MSR Router Series IP Multicast Command Reference(V5)

160
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] igmp-snooping static-group 232.1.1.1 source-ip 1.1.1.1 vlan 2
igmp-snooping static-router-port
Use igmp-snooping static-router-port to configure a port as a static router port.
Use undo igmp-snooping static-router-port to restore the default.
Syntax
igmp-snooping static-router-port vlan vlan-id
undo igmp-snooping static-router-port vlan vlan-id
Default
No ports are static router ports.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default command level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN by its ID, in the range of 1 to 4094.
Usage guidelines
This command also takes effect on VLANs with IGMP enabled on their VLAN interfaces.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN.
In port group view, this command takes effect only on those ports in this port group that belong to the
specified VLAN.
Examples
# Configure Ethernet 1/1 in VLAN 2 as a static router port.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] igmp-snooping static-router-port vlan 2
igmp-snooping version
Use igmp-snooping version to specify the IGMP snooping version.
Use undo igmp-snooping version to restore the default.
Syntax
igmp-snooping version version-number
undo igmp-snooping version
Default
The IGMP snooping version is IGMPv2 snooping.