R2511-HP MSR Router Series IP Multicast Command Reference(V5)

161
Views
VLAN view
Default command level
2: System level
Parameters
version-number: Specifies an IGMP snooping version in the range of 2 to 3.
Usage guidelines
This command can take effect only if IGMP snooping is enabled in the VLAN.
Examples
# Enable IGMP snooping and specify the IGMP snooping version to IGMPv3 snooping in VLAN 2.
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping version 3
Related commands
igmp-snooping enable
last-member-query-interval (IGMP-snooping view)
Use last-member-query-interval to configure the IGMP last-member query interval globally.
Use undo last-member-query-interval to restore the default.
Syntax
last-member-query-interval interval
undo last-member-query-interval
Default
The default setting is 1 second.
Views
IGMP-snooping view
Default command level
2: System level
Parameters
interval: Sets the IGMP last-member query interval in seconds. The value range is 1 to 5.
Usage guidelines
The IGMP last-member query interval determines the interval for sending IGMP group-specific queries
and the maximum response delay for IGMP group-specific queries.
Examples
# Set the IGMP last-member query interval to 3 seconds globally.
<Sysname> system-view