R2511-HP MSR Router Series IP Multicast Command Reference(V5)

177
Default
MSDP is disabled.
Views
System view
Default command level
2: System level
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN by its name, a case-sensitive string of 1 to 31
characters. If you do not specify this option, the command applies to the public network.
Usage guidelines
You must enable IP multicast in the corresponding VPN instance before you use this command.
Examples
# Enable IP multicast routing on the public network, and enable MSDP on the public network to enter
public network MSDP view.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] msdp
[Sysname-msdp]
# Enable IP multicast routing in VPN instance mvpn, and enable MSDP in VPN instance mvpn to enter
MSDP view of VPN instance mvpn.
<Sysname> system-view
[Sysname] ip vpn-instance mvpn
[Sysname-vpn-instance-mvpn] route-distinguisher 100:1
[Sysname-vpn-instance-mvpn] multicast routing-enable
[Sysname-vpn-instance-mvpn] quit
[Sysname] msdp vpn-instance mvpn
[Sysname-msdp-mvpn]
Related commands
multicast routing-enable
originating-rp
Use originating-rp to configure the address of the specified interface as the RP address of SA messages.
Use undo originating-rp to restore the default.
Syntax
originating-rp interface-type interface-number
undo originating-rp
Default
The PIM RP address is used as the RP address of SA messages.
Views
Public network MSDP view, VPN instance MSDP view