R2511-HP MSR Router Series IP Multicast Command Reference(V5)

239
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] preference 20 20 200
reflect between-clients (MBGP address family view)
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
Syntax
reflect between-clients
undo reflect between-clients
Default
Route reflection between clients is enabled.
Views
IPv4 MBGP address family view
Default command level
2: System level
Usage guidelines
After a route reflector is configured, it reflects the routes of a client to other clients. If the clients of a route
reflector are fully meshed, you must disable route reflection between clients to reduce routing costs.
Examples
# Disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family multicast
[Sysname-bgp-af-mul] undo reflect between-clients
Related commands
• reflector cluster-id
• peer reflect-client
reflector cluster-id (MBGP address family view)
Use reflector cluster-id to configure the cluster ID for the route reflectors.
Use undo reflector cluster-id to remove the configured cluster ID.
Syntax
reflector cluster-id { cluster-id | ip-address }
undo reflector cluster-id
Default
Each route reflector uses its router ID as the cluster ID.