R2511-HP MSR Router Series IP Multicast Command Reference(V5)

258
Usage guidelines
To specify a multicast group address on the public network SSM group range as a share-group address,
you must first configure BGP MDT peers or peer groups.
On the same PE device, different VPN instances must not have the same group address, and
group-address must not coincide with the switch-group address of any VPN instance; in addition,
mtunnel-number must not coincide with the number of any MTI already created.
This command must not be used multiple times in the same VPN instance view. To configure a new group
address and MTI for a VPN instance, you must remove the existing configuration.
The undo multicast-domain share-group command removes the configured MTI and the configurations
of the multicast-domain switch-group-pool, multicast-domain log switch-group-reuse and
multicast-domain switch-delay commands.
Enable IP multicast routing for the VPN instance before you configure this command.
Related commands
• multicast routing-enable
• multicast-domain log switch-group-reuse
• multicast-domain switch-delay
• multicast-domain switch-group-pool
Examples
# Specify 224.1.1.1 as the share-group address in VPN instance mvpn and associate MTI 0 with the VPN
instance.
<Sysname> system-view
[Sysname] ip vpn-instance mvpn
[Sysname-vpn-instance-mvpn] multicast-domain share-group 224.1.1.1 binding mtunnel 0
multicast-domain switch-delay
Use multicast-domain switch-delay to configure the switch-delay period.
Use undo multicast-domain switch-delay to restore the default.
Syntax
multicast-domain switch-delay switch-delay
undo multicast-domain switch-delay
Views
VPN instance view
Default command level
2: System level
Parameters
switch-delay: Switch-delay period in seconds, namely, the delay time for multicast traffic to be switched
from the share-MDT to the switch-MDT, in the range of 3 to 60.
Default
The switch-delay period is 5 seconds.