R2511-HP MSR Router Series IP Multicast Command Reference(V5)

346
Default command level
2: System level
Usage guidelines
This command can take effect only after IPv6 multicast routing is enabled on the device.
Examples
# Enable IPv6 multicast routing, and enable IPv6 PIM-SM on Ethernet 1/1.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] pim ipv6 sm
Related commands
• multicast ipv6 routing-enable
• pim ipv6 dm
pim ipv6 state-refresh-capable
Use pim ipv6 state-refresh-capable to enable the state refresh feature on the interface.
Use undo pim ipv6 state-refresh-capable to disable the state refresh feature.
Syntax
pim ipv6 state-refresh-capable
undo pim ipv6 state-refresh-capable
Default
The state refresh feature is enabled.
Views
Interface view
Default command level
2: System level
Examples
# Disable state refresh on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] undo pim ipv6 state-refresh-capable
Related commands
• state-refresh-hoplimit
• state-refresh-interval
• state-refresh-rate-limit
pim ipv6 timer graft-retry
Use pim ipv6 timer graft-retry to configure the graft retry period.
Use undo pim ipv6 timer graft-retry to restore the default.