R2511-HP MSR Router Series IP Multicast Command Reference(V5)

348
Related commands
timer hello
pim ipv6 timer join-prune
Use pim ipv6 timer join-prune to configure the interval at which join/prune messages are sent on the
current interface.
Use undo pim ipv6 timer join-prune to restore the default.
Syntax
pim ipv6 timer join-prune interval
undo pim ipv6 timer join-prune
Default
The join/prune interval is 60 seconds.
Views
Interface view
Default command level
2: System level
Parameters
interval: Specifies a join/prune interval in seconds. The value range is 1 to 2,147,483,647.
Examples
# Set the join/prune interval to 80 seconds on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] pim ipv6 timer join-prune 80
Related commands
timer join-prune
pim ipv6 triggered-hello-delay
Use pim ipv6 triggered-hello-delay to configure the maximum delay between hello messages.
Use undo pim ipv6 triggered-hello-delay to restore the default.
Syntax
pim ipv6 triggered-hello-delay interval
undo pim ipv6 triggered-hello-delay
Default
The maximum delay between hello messages is 5 seconds.
Views
Interface view
Default command level
2: System level