R2511-HP MSR Router Series IP Multicast Command Reference(V5)

349
Parameters
interval: Specifies the maximum delay in seconds between hello messages. The value range is 1 to 5.
Examples
# Set the maximum delay between hello messages to 3 seconds on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] pim ipv6 triggered-hello-delay 3
probe-interval (IPv6 PIM view)
Use probe-interval to configure the register probe time.
Use undo probe-interval to restore the default.
Syntax
probe-interval interval
undo probe-interval
Default
The register probe time is 5 seconds.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: Specifies a register probe time in seconds. The value range is 1 to 1799.
Examples
# Set the register probe time to 6 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] probe-interval 6
Related commands
register-suppression-timeout
prune delay (IPv6 PIM view)
Use prune delay to set the prune delay timer (namely, the time that the device waits between receiving
a prune message and taking a prune action).
Use undo prune delay to restore the default.
Syntax
prune delay interval
undo prune delay