R2511-HP MSR Router Series IP Multicast Command Reference(V5)

356
Views
IPv6 PIM view
Default command level
2: System level
Parameters
hoplimit-value: Specifies a hop limit for state refresh messages, in the range of 1 to 255.
Examples
# Set the hop limit for state refresh messages to 45.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-hoplimit 45
Related commands
• pim ipv6 state-refresh-capable
• state-refresh-interval
• state-refresh-rate-limit
state-refresh-interval (IPv6 PIM view)
Use state-refresh-interval to configure the interval between state refresh messages.
Use undo state-refresh-interval to restore the default.
Syntax
state-refresh-interval interval
undo state-refresh-interval
Default
The state refresh interval is 60 seconds.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: State refresh interval in seconds. The value range is 1 to 255.
Examples
# Set the state refresh interval to 70 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-interval 70
Related commands
• pim ipv6 state-refresh-capable
• state-refresh-hoplimit