R2511-HP MSR Router Series IP Multicast Command Reference(V5)

360
timer spt-switch (IPv6 PIM view)
Use timer spt-switch to configure the interval between checks of the traffic rate threshold before an SPT
switchover.
Use undo timer spt-switch to restore the default.
Syntax
timer spt-switch interval
undo timer spt-switch
Default
The traffic rate threshold is checked at an interval of 15 seconds before an SPT switchover.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: Specifies an interval in seconds between checks of the traffic rate threshold prior to an SPT
switchover. The value range is 15 to 65535.
Usage guidelines
Before using this command, be sure to use the spt-switch-threshold command to configure the traffic rate
threshold that should trigger an SPT switchover. Otherwise, the interval set in this command does not take
effect.
Examples
# Set the interval between checks of the traffic rate threshold prior to an SPT switchover to 30 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] timer spt-switch 30
Related commands
spt-switch-threshold