R2511-HP MSR Router Series IP Multicast Command Reference(V5)

373
undo multicast ipv6 load-splitting
Default
Load splitting of IPv6 multicast traffic is disabled.
Views
System view
Default command level
2: System level
Parameters
source: Specifies IPv6 multicast load splitting on a per-source basis.
source-group: Specifies IPv6 multicast load splitting on a per-source and per-group basis.
Examples
# Enable load splitting of IPv6 multicast traffic on a per-source basis.
<Sysname> system-view
[Sysname] multicast ipv6 load-splitting source
multicast ipv6 longest-match
Use multicast ipv6 longest-match to configure RPF route selection based on the longest match principle,
namely, to select the route with the longest prefix as the RPF route.
Use undo multicast ipv6 longest-match to restore the default.
Syntax
multicast ipv6 longest-match
undo multicast ipv6 longest-match
Default
The route with the highest priority is selected as the RPF route.
Views
System view
Default command level
2: System level
Examples
# Configure RPF route selection based on the longest match.
<Sysname> system-view
[Sysname] multicast ipv6 longest-match
multicast ipv6 minimum-hoplimit
Use multicast ipv6 minimum-hoplimit to configure the minimum hop limit required for an IPv6 multicast
packet to be forwarded.
Use undo multicast ipv6 minimum-hoplimit to restore the default.