R2511-HP MSR Router Series IP Multicast Command Reference(V5)

387
Default command level
2: System level
Examples
# Enable MLD snooping globally and enter MLD-snooping view.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping]
Related commands
mld-snooping enable
mld-snooping done source-ip
Use mld-snooping done source-ip to configure the source IPv6 address of the MLD done messages that
the MLD snooping proxy sends.
Use undo mld-snooping done source-ip to restore the default.
Syntax
mld-snooping done source-ip { ipv6-address | current-interface }
undo mld-snooping done source-ip
Default
The source IPv6 address of the MLD done messages that the MLD snooping proxy sends is
FE80::02FF:FFFF:FE00:0001.
Views
VLAN view
Default command level
2: System level
Parameters
ipv6-address: Specifies a source IPv6 address for the MLD done messages that the MLD snooping proxy
sends, which can be any legal IPv6 link-local address.
current-interface: Specifies the IPv6 link-local address of the current VLAN interface as the source
address of MLD done messages that the MLD snooping proxy sends. If no IPv6 address has been
assigned to the current interface, the default IPv6 address FE80::02FF:FFFF:FE00:0001 is used.
Usage guidelines
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
The source IPv6 address configured in the mld-snooping done source-ip command also applies when
the simulated host sends MLD done messages.
Examples
# In VLAN 2, enable MLD snooping and configure the source IPv6 address of MLD done messages that
the MLD snooping proxy sends to FE80:0:0:1::1.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit