R2511-HP MSR Router Series IP Multicast Command Reference(V5)

390
Syntax
mld-snooping enable
undo mld-snooping enable
Default
MLD snooping is disabled.
Views
VLAN view
Default command level
2: System level
Usage guidelines
You must enable MLD snooping globally before you enable it for a VLAN.
Examples
# Enable MLD snooping for VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
Related commands
mld-snooping
mld-snooping fast-leave
Use mld-snooping fast-leave to enable fast-leave processing on a port. With this function enabled, when
the device receives an MLD done message on the port, it directly removes that port from the forwarding
table entry for the specific IPv6 multicast group.
Use undo mld-snooping fast-leave to disable fast-leave processing on a port.
Syntax
mld-snooping fast-leave [ vlan vlan-list ]
undo mld-snooping fast-leave [ vlan vlan-list ]
Default
Fast-leave processing is disabled.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default command level
2: System level
Parameters
vlan vlan-list: Specifies one or multiple VLANs. You can provide up to 10 VLAN lists. For each list, you
can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id to