R2511-HP MSR Router Series IP Multicast Command Reference(V5)

401
Default
The MLD query interval is 125 seconds.
Views
VLAN view
Default command level
2: System level
Parameters
interval: Specifies an MLD query interval in seconds, namely, the interval for sending MLD general
queries. The value range is 2 to 300.
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command for the VLAN.
Examples
# Enable MLD snooping and set the MLD query interval to 20 seconds in VLAN 2.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping query-interval 20
Related commands
• max-response-time
• mld-snooping enable
• mld-snooping max-response-time
• mld-snooping querier
mld-snooping report source-ip
Use mld-snooping report source-ip to configure the source IPv6 address for the MLD reports that the MLD
snooping proxy sends.
Use undo mld-snooping report source-ip to restore the default.
Syntax
mld-snooping report source-ip { ipv6-address | current-interface }
undo mld-snooping report source-ip
Default
The source IPv6 address of the MLD reports that the MLD snooping proxy sends is
FE80::02FF:FFFF:FE00:0001.
Views
VLAN view
Default command level
2: System level