R2511-HP MSR Router Series IP Multicast Command Reference(V5)

402
Parameters
ipv6-address: Specifies a source IPv6 address for the MLD reports that the MLD snooping proxy sends,
which can be any legal IPv6 link-local address.
current-interface: Specifies the IPv6 link-local address of the current VLAN interface as the source
address of MLD reports that the MLD snooping proxy sends. If no IPv6 address has been assigned to the
current interface, the default IPv6 address FE80::02FF:FFFF:FE00:0001 is used.
Usage guidelines
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
The source IPv6 address configured in the mld-snooping report source-ip command also applies when
the simulated host sends MLD reports.
Examples
# In VLAN 2, enable MLD snooping and configure the source IPv6 address for the MLD reports that the
MLD snooping proxy sends to FE80:0:0:1::1.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping report source-ip fe80:0:0:1::1
Related commands
mld-snooping enable
mld-snooping router-aging-time
Use mld-snooping router-aging-time to set the aging timer for the dynamic router ports in the current
VLAN.
Use undo mld-snooping router-aging-time to restore the default.
Syntax
mld-snooping router-aging-time interval
undo mld-snooping router-aging-time
Default
The dynamic router port aging timer is 260 seconds.
Views
VLAN view
Default command level
2: System level
Parameters
interval: Specifies an aging timer in seconds for the dynamic router ports. The value range is 1 to 1000.
Usage guidelines
You must enable MLD snooping for a VLAN before you execute this command for the VLAN.