R2511-HP MSR Router Series IP Multicast Command Reference(V5)

406
Usage guidelines
The source-ip ipv6-source-address option in the command is meaningful only for MLDv2 snooping. If
MLDv1 snooping is running, the source-ip ipv6-source-address option does not take effect although you
can include source-ip ipv6-source-address in the command.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this feature takes effect only if the
interface belongs to the specified VLAN. In port group view, this feature takes effect only on those ports
in this port group that belong to the specified VLAN.
Examples
# Configure Ethernet 1/1 in VLAN 2 as a static member port for the IPv6 multicast source and group
(2002::22, FF3E::101).
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping version 2
[Sysname-vlan2] quit
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] mld-snooping static-group ff3e::101 source-ip 2002::22 vlan 2
mld-snooping static-router-port
Use mld-snooping static-router-port to configure a port as a static router port.
Use undo mld-snooping static-router-port to restore the default.
Syntax
mld-snooping static-router-port vlan vlan-id
undo mld-snooping static-router-port vlan vlan-id
Default
No ports are static router ports.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default command level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN by its ID. The value range is 1 to 4094.
Usage guidelines
For a device that supports both MLD snooping and MLD, this command also takes effect on VLANs with
MLD enabled on their VLAN interfaces.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this feature takes effect only if the
interface belongs to the specified VLAN. In port group view, this feature takes effect only on those ports
in this port group that belong to the specified VLAN.