R2511-HP MSR Router Series IP Multicast Command Reference(V5)

29
Default command level
2: System level
Parameters
interval: Startup query interval in seconds, namely, the interval between general queries that the IGMP
querier sends on startup. The value range is 1 to 18000.
Examples
# Set the startup query interval to 5 seconds on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] igmp startup-query-interval 5
Related commands
• igmp timer query
• startup-query-interval
igmp static-group
Use igmp static-group to configure the current interface as a static member of the specified multicast
group or the specified multicast source and group.
Use undo igmp static-group to restore the default.
Syntax
igmp static-group group-address [ source source-address ]
undo igmp static-group { all | group-address [ source source-address ] }
Default
An interface is not a static member of any multicast group or multicast source and group.
Views
Interface view
Default command level
2: System level
Parameters
group-address: Specifies a multicast group address in the range of 224.0.1.0 to 239.255.255.255.
source-address: Specifies a multicast source address.
all: Specifies all static multicast groups that the current interface has joined.
Usage guidelines
If the specified multicast address is in the SSM multicast address range, you must specify a multicast
source address at the same time. Otherwise, IGMP routing table entries cannot be established. No such
a restriction exists if the specified multicast group address is not in the SSM multicast address range.
For a device that supports both IGMP snooping and IGMP, if you want to configure a VLAN interface as
a static member of a multicast group or multicast source and group, configure the igmp static-group
command on the VLAN interface, and configure the igmp-snooping static-group command on the
member ports of the corresponding VLAN.