R2511-HP MSR Router Series IP Multicast Command Reference(V5)

441
Default command level
2: System level
Parameters
protocol: Specifies a routing protocol, which can be direct, isisv6, ospfv3, ripng, or static.
process-id: Specifies a process by its ID in the range of 1 to 65535. This argument is available when the
protocol is isisv6, ospfv3, or ripng.
med-value: Specifies a default MED value in the range of 0 to 4294967295. If no MED is specified, the
system uses the cost of a redistributed route as the MED in the BGP routing domain.
route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63 characters.
Usage guidelines
The origin attribute of routes redistributed with the import-route command is incomplete.
Examples
# Redistribute routes from RIPng 1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] import-route ripng 1
ipv6-family multicast
Use ipv6-family multicast to enter IPv6 MBGP address family view.
Use undo ipv6-family multicast to remove all the configurations in the IPv6 MBGP address family view.
Syntax
ipv6-family multicast
undo ipv6-family multicast
Default
IPv4 BGP unicast view is the default.
Views
BGP view
Default command level
2: System level
Usage guidelines
If the ipv6-family command is not configured in BGP view, you cannot directly configure the ipv6-family
multicast command in BGP view (see example 1). If the ipv6-family command is configured in BGP view,
you can directly configure the ipv6-family multicast command in BGP view (see example 2).
Examples
• Example 1:
# Enter IPv6 MBGP address family view.
<Sysname> system-view
[Sysname] bgp 100