R2511-HP MSR Router Series IP Multicast Configuration Guide(V5)

122
Step Command Remarks
2. Configure a static multicast
route.
ip rpf-route-static [ vpn-instance
vpn-instance-name ]
source-address { mask |
mask-length } [ protocol
[ process-id ] ] [ route-policy
policy-name ] { rpf-nbr-address |
interface-type interface-number }
[ preference preference ] [ order
order-number ]
By default, no static multicast route
is configured.
When you configure a static
multicast route, you cannot specify
an RPF neighbor by providing the
type and number of the interface if
the interface is a Layer 3 Ethernet
interface, Layer 3 aggregate
interface, loopback interface, or
VLAN interface. Instead, you can
specify such an RPF neighbor only
by its address.
3. Delete static multicast routes.
delete ip rpf-route-static
[ vpn-instance vpn-instance-name ]
Optional.
Configuring a multicast routing policy
You can configure the router to determine the RPF route based on the longest prefix match principle. For
more information about RPF route selection, see "RPF check process."
By configuring per-source or per-source-and-group load splitting, you can optimize the traffic delivery
when multiple data flows are handled.
Configuring a multicast routing policy for the public network
Step Command Remarks
1. Enter system view.
system-view N/A
2. Configure the device to select
the RPF route based on the
longest prefix match principle.
multicast longest-match
The route with the highest priority is
selected as the RPF route by
default.
3. Configure multicast load
splitting.
multicast load-splitting { source |
source-group }
Optional.
Disabled by default.
Configuring a multicast routing policy in a VPN instance
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VPN instance view.
ip vpn-instance
vpn-instance-name
N/A
3. Configure the device to
select the RPF route based on
the longest prefix match
principle.
multicast longest-match
The route with the highest priority is
selected as the RPF route by default.
4. Configure multicast load
splitting.
multicast load-splitting { source |
source-group }
Optional.
Disabled by default.