R2511-HP MSR Router Series IP Multicast Configuration Guide(V5)

164

Figure 49 Network diagram

Configuration procedure

1. Assign an IP address and subnet mask to each interface according to Figure 49. (Details not

shown.)

2. On Router A, enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on

Ethernet 1/1.

<RouterA> system-view

[RouterA] multicast routing-enable

[RouterA] interface ethernet 1/1

[RouterA-Ethernet1/1] igmp enable

[RouterA-Ethernet1/1] pim dm

[RouterA-Ethernet1/1] quit

[RouterA] interface ethernet 1/2

[RouterA-Ethernet1/2] pim dm

[RouterA-Ethernet1/2] quit

3. Configure Switch A:

# Enable IGMP snooping globally.

<SwitchA> system-view

[SwitchA] igmp-snooping

[SwitchA-igmp-snooping] quit

# Create VLAN 100, assign ports Ethernet 1/1 through Ethernet 1/4 to this VLAN, and enable

IGMP snooping and IGMP snooping proxying in the VLAN.

[SwitchA] vlan 100

[SwitchA-vlan100] port ethernet 1/1 to ethernet 1/4

[SwitchA-vlan100] igmp-snooping enable

[SwitchA-vlan100] igmp-snooping proxying enable

[SwitchA-vlan100] quit