R2511-HP MSR Router Series IP Multicast Configuration Guide(V5)

352
Device Interface IPv6 address Device Interface IPv6 address
Router C S2/1 3002::1/64 Router F POS5/1 6002::2/64
Router C S2/2 3003::1/64 Router F POS5/2 2003::2/64
Router C POS5/1 2002::2/64 Router G Eth1/1 9001::1/64
Router C POS5/2 3004::1/64 Router G S2/1 8001::2/64
Router H S2/1 4001::1/64 Source 1 — 2001::100/64
Router H POS5/1 3004::2/64 Source 2 — 3001::100/64
Router I Eth1/1 5001::1/64 Source 3 — 9001::100/64
Router I S2/1 4001::2/64 — — —
Configuration procedure
1. Configure the IPv6 address and prefix length for each interface according to Figure 97. (Details
not shown.)
2. Configure OSPFv3 on the routers in the IPv6 PIM-SM domain to ensure network-layer reachability
among them. (Details not shown.)
3. Enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM and MLD:
# Enable IPv6 multicast routing and IPv6 administrative scoping on Router A, enable IPv6 PIM-SM
on each interface, and enable MLD on the host-side interface Ethernet 1/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] pim ipv6
[RouterA-pim6] c-bsr admin-scope
[RouterA-pim6] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] pim ipv6 sm
[RouterA-Ethernet1/1] quit
[RouterA] interface serial 2/1
[RouterA-Serial2/1] pim ipv6 sm
[RouterA-Serial2/1] quit
# Enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM and
MLD on Router E and Router I in the same way. (Details not shown.)
# On Router B, enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6
PIM-SM on each interface.
<RouterB> system-view
[RouterB] multicast ipv6 routing-enable
[RouterB] pim ipv6
[RouterB-pim6] c-bsr admin-scope
[RouterB-pim6] quit
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] pim ipv6 sm
[RouterB-Ethernet1/1] quit
[RouterB] interface serial 2/1
[RouterB-Serial2/1] pim ipv6 sm