R2511-HP MSR Router Series IP Multicast Configuration Guide(V5)

394
Step Command Remarks
4. Set the global aging timer for
dynamic member ports.
host-aging-time interval 260 seconds by default.
Setting the aging timers for the dynamic ports in a VLAN
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Set the aging timer for the
dynamic router ports.
mld-snooping router-aging-time
interval
260 seconds by default.
4. Set the aging timer for the
dynamic member ports.
mld-snooping host-aging-time
interval
260 seconds by default.
Configuring static ports
If all hosts attached to a port are interested in the IPv6 multicast data addressed to a particular IPv6
multicast group, you can configure the port as a static member port for that IPv6 multicast group.
You can configure a port as a static router port, through which the switch can forward all IPv6 multicast
data that it received.
Configuration guidelines
• A static member port does not respond to queries from the MLD querier. When you configure a port
as a static member port or cancel this configuration on the port, the port does not send an
unsolicited MLD report or an MLD done message.
• Static member ports and static router ports never age out. To remove such a port, use the
corresponding undo command.
Configuration procedure
To configure static ports:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view or
enter port group view.
• Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Use either method.
3. Configure the port as a static
member port.
mld-snooping static-group
ipv6-group-address [ source-ip
ipv6-source-address ] vlan vlan-id
No static member ports by default.
4. Configure the port as a static
router port.
mld-snooping static-router-port
vlan vlan-id
No static router ports by default.