R2511-HP MSR Router Series IP Multicast Configuration Guide(V5)

435
Configuration procedure
1. Configure IPv6 addresses for router interfaces as shown in Figure 110. (Details not shown.)
2. Configure OSPFv3. (Details not shown.)
3. Enable IPv6 multicast routing, IPv6 PIM-SM and MLD, and configure an IPv6 PIM-SM domain
border:
# Enable IPv6 multicast routing on Router A, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] pim ipv6 sm
[RouterA-Ethernet1/1] quit
[RouterA] interface pos 5/0
[RouterA-Pos5/0] pim ipv6 sm
[RouterA-Pos5/0] quit
The configuration on Router B and Router D is similar to the configuration on Router A.
# Enable IPv6 multicast routing on Router C, enable IPv6 PIM-SM on each interface, and enable
MLD on the host-side interface Ethernet 1/1.
<RouterC> system-view
[RouterC] multicast ipv6 routing-enable
[RouterC] interface serial 2/0
[RouterC-Serial2/0] pim ipv6 sm
[RouterC-Serial2/0] quit
[RouterC] interface serial 2/1
[RouterC-Serial2/1] pim ipv6 sm
[RouterC-Serial2/1] quit
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] pim ipv6 sm
[RouterC-Ethernet1/1] mld enable
[RouterC-Ethernet1/1] quit
# Configure an IPv6 PIM domain border on Router A.
[RouterA] interface pos 5/0
[RouterA-Pos5/0] pim ipv6 bsr-boundary
[RouterA-Pos5/0] quit
# Configure an IPv6 PIM domain border on Router B.
[RouterB] interface pos 5/0
[RouterB-Pos5/0] pim ipv6 bsr-boundary
[RouterB-Pos5/0] quit
4. Configure the position of C-BSR and C-RP:
# Configure the position of C-BSR and C-RP on Router A.
[RouterA] pim ipv6
[RouterA-pim6] c-bsr 1001::1
[RouterA-pim6] c-rp 1001::1
[RouterA-pim6] quit
# Configure the position of C-BSR and C-RP on Router B.
[RouterB] pim ipv6