R2511-HP MSR Router Series IP Multicast Configuration Guide(V5)

72
Enabling PIM-SM
Because BIDIR-PIM is implemented on the basis of PIM-SM, you must enable PIM-SM before enabling
BIDIR-PIM. To deploy a BIDIR-PIM domain, enable PIM-SM on all non-border interfaces of the domain.
IMPORTANT:
A
ll interfaces on a device must be enabled with the same PIM mode.
Enabling PIM-SM globally for the public network
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IP multicast routing.
multicast routing-enable Disabled by default.
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Enable PIM-SM.
pim sm Disabled by default.
Enabling PIM-SM for a VPN instance
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Create a VPN instance and
enter VPN instance view.
ip vpn-instance vpn-instance-name
N/A
For more information about this
command, see MPLS Command
Reference.
3. Configure an RD for the VPN
instance.
route-distinguisher
route-distinguisher
Not configured by default.
For more information about this
command, see MPLS Command
Reference.
4. Enable IP multicast routing.
multicast routing-enable Disabled by default.
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Bind the interface with the
VPN instance.
ip binding vpn-instance
vpn-instance-name
By default, an interface belongs to
the public network, and is not
bound with any VPN instance.
For more information about this
command, see MPLS Command
Reference.
7. Enable PIM-SM.
pim sm Disabled by default.
Enabling BIDIR-PIM
Perform this configuration on all routers in the BIDIR-PIM domain.
To enable BIDIR-PIM: