R2511-HP MSR Router Series IPX Command Reference(V5)

16
ipx route max-reserve-path
Use ipx route max-reserve-path to specify the maximum number of routes to the same destination.
Use undo ipx route max-reserve-path to restore the default.
Syntax
ipx route max-reserve-path paths
undo ipx route max-reserve-path
Default
The value is 4.
Views
System view
Default command level
2: System level
Parameters
paths: Maximum number of routes to the same destination, including both static and dynamic routes, in
the range of 1 to 255.
Usage guidelines
When the route number to the same destination address exceeds the maximum value configured, the
newly found dynamic routes will not be added into the routing table, but discarded directly. If the newly
configured value is less than the original one, the excessive routes in the current routing table will not be
deleted until they get aged out or are deleted manually.
Examples
# Specify the maximum number of routes to the same destination to 200.
<Sysname> system-view
[Sysname] ipx route max-reserve-path 200
ipx sap disable
Use ipx sap disable to disable IPX SAP on the current interface.
Use undo ipx sap disable to enable IPX SAP on the current interface.
Syntax
ipx sap disable
undo ipx sap disable
Default
The SAP is enabled on the interface after IPX is enabled.
Views
Interface view
Default command level
2: System level