R2511-HP MSR Router Series IPX Configuration Guide(V5)

8
The type 20 IPX packet is used in NetBIOS. You can either prohibit or permit the forwarding of type 20
broadcast packets based on the actual requirements.
To configure IPX triggered updating feature:
Ste
p
Command Remar
k
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable the IPX triggered
update feature.
ipx update-change-only Disabled by default.
4. Enable the IPX split horizon
feature.
ipx split-horizon
Optional.
Enabled by default.
5. Configure the encapsulation
format of IPX frames.
ipx encapsulation [ dot2 | dot3 |
ethernet-2 | snap ]
Optional.
The default is Ethernet_802.3
(dot3).
6. Configure an IPX forwarding
delay.
ipx tick ticks
Optional.
By default, 1 tick for Ethernet
interfaces and VLAN interfaces, 30
ticks for asynchronous serial ports, 6
ticks for synchronous ports, with
each tick roughly being 1/18
second.
7. Enable the forwarding of
type 20 packets.
ipx netbios-propagation Disabled by default.
Pinging an IPX network
Configuration prerequisites
Configure basic IPX.
Configuration procedure
To ping an IPX network:
Task Command Remar
k
Ping an IPX network to check
connectivity.
ping ipx network.node [ -c count |
-s size | -t timeout ] *
Available in any view.
Displaying and maintaining IPX configuration
Task Command Remar
k
Display IPX interface
information.
display ipx interface [ interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.