R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

108
Parameters
system-priority: Specifies the LACP priority of the local system, in the range of 0 to 65535. The smaller the
value, the higher the system LACP priority.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64
link-aggregation mode
Use link-aggregation mode dynamic to configure an aggregation group to operate in dynamic
aggregation mode.
Use undo link-aggregation mode to restore the default setting.
Syntax
link-aggregation mode dynamic
undo link-aggregation mode
Default
An aggregation group operates in static aggregation mode.
Views
Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default command level
2: System level
Usage guidelines
To change the aggregation mode of an aggregation group that contains member ports, remove all the
member ports from the aggregation group first.
The following matrix shows the command and router compatibility in Layer 2 aggregate interface view:
Command MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
link-aggregation
mode
No Yes No No Yes Yes Yes
Examples
# Configure the aggregation group corresponding to Bridge-Aggregation 1 to operate in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
link-aggregation port-priority
Use link-aggregation port-priority to set the aggregation priority of a port.
Use undo link-aggregation port-priority to restore the default setting.