R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

140
Field Descri
p
tion
LLDP-MED extend TLV
LLDP-MED TLVs:
• Capabilities TLV.
• Network Policy TLV.
• Extended Power-via-MDI TLV.
• Location Identification TLV.
• Inventory TLV, including hardware revision TLV, firmware revision TLV,
software revision TLV, serial number TLV, manufacturer name TLV,
model name TLV, and asset id TLV.
lldp admin-status
Use lldp admin-status to specify the LLDP operating mode for a port or all ports in a port group.
Use undo lldp admin-status to restore the default LLDP operating mode.
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
Default
The LLDP operating mode is TxRx.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode only receives LLDPDUs.
tx: Specifies the Tx mode. A port in this mode only sends LLDPDUs.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Examples
# Configure the LLDP operating mode as Rx for Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] lldp admin-status rx
lldp check-change-interval
Use lldp check-change-interval to enable LLDP polling and to set the polling interval.
Use undo lldp check-change-interval to restore the default.
Syntax
lldp check-change-interval interval