R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

141
undo lldp check-change-interval
Default
LLDP polling is disabled.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level
Parameters
interval: Sets the LLDP polling interval in the range of 1 to 30 seconds.
Examples
# Enable LLDP polling on Ethernet 1/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] lldp check-change-interval 30
lldp enable
Use lldp enable to enable LLDP.
Use undo lldp enable to disable LLDP.
Syntax
lldp enable
undo lldp enable
Default
LLDP is enabled on a port and is globally disabled.
Views
System view, Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level
Usage guidelines
LLDP takes effect on a port only when LLDP is enabled both globally and on the port.
Examples
# Disable LLDP on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] undo lldp enable
lldp encapsulation snap
Use lldp encapsulation snap to configure the encapsulation format for LLDPDUs as SNAP on a port or a
group of ports.