R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

27
Interface PVID VLAN passing
Eth1/4 100 Tagged: 1000, 1002, 1500, 1600-1611, 2000,
2555-2558, 3000, 4000
Untagged:1, 10, 15, 18, 20-30, 44, 55, 67, 100,
150-160, 200, 255, 286, 300-302
# Display information about the trunk ports in the system.
<Sysname> display port trunk
Interface PVID VLAN passing
Eth1/8 2 1-4, 6-100, 145, 177, 189-200, 244, 289, 400,
555, 600-611, 1000, 2006-2008
Table 6 Command output
Field Description
Interface Port name.
PVID Port VLAN ID.
VLAN passing VLANs for which the port allows packets to pass through.
Tagged VLANs for which the port sends packets without removing VLAN tags.
Untagged VLANs for which the port sends packets after removing VLAN tags.
port
Use port to assign the specified access ports to the VLAN.
Use undo port to remove the specified access ports from the VLAN.
Syntax
port interface-list
undo port interface-list
Default
All ports are in VLAN 1. All ports are access ports. However, you can manually configure the port type.
For more information, see "port link-type."
Views
VLAN view
Default command level
2: System level
Parameters
interface-list: Specifies an interface list, in the format of interface-list = { interface-type interface-number1
[ to interface-type interface-number2 ] }&<1-10>, where interface-type interface-number specifies an
interface by its type and number and &<1-10> indicates that you can specify up to 10 ports or port
ranges.
Usage guidelines
This command is only applicable on access ports.
You cannot assign Layer 2 aggregate interfaces to a VLAN.