R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

28
Examples
# Assign Ethernet 1/1 through Ethernet 1/3 to VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] port ethernet 1/1 to ethernet 1/3
Related commands
display vlan
port access vlan
Use port access vlan to assign the access ports to the specified VLAN.
Use undo port access vlan to restore the default.
Syntax
port access vlan vlan-id
undo port access vlan
Default
All access ports belong to VLAN 1 and do not belong to any other VLAN.
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094. Make sure that the VLAN specified by the VLAN
ID already exists.
Usage guidelines
The following matrix shows the command and router compatibility:
Command MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
port access vlan
(Layer 2 aggregate
interface view)
No Yes No No Yes Yes Yes
The configuration made in Ethernet interface view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
• If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
Examples
# Assign Ethernet 1/1 to VLAN 3.
<Sysname> system-view