R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

29
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] port access vlan 3
# Assign Layer 2 aggregate interface Bridge-Aggregation 1 and its member ports to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port access vlan 3
port hybrid pvid
Use port hybrid pvid to configure the PVID of the hybrid port.
Use undo port hybrid pvid to restore the default.
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
Default
The PVID of a hybrid port is VLAN 1.
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
The following matrix shows the command and router compatibility:
Command MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
port hybrid pvid
(Layer 2 aggregate
interface view)
No Yes No No Yes Yes Yes
You can use a nonexistent VLAN as the PVID for a hybrid port. If you use the undo vlan command to
remove the PVID of a hybrid port, it does not affect the setting of the PVID on the port.
HP recommends that you set the same PVID for the local and remote hybrid ports.
You must use the port hybrid vlan command to configure the hybrid port to permit the packets from the
PVID to pass through.
The configuration made in Ethernet interface view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.