R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

32
Configuring Ethernet1/1... Done.
Configuring Ethernet1/2... Done.
Configuring Ethernet1/3... Done.
The output shows that Ethernet 1/1, Ethernet 1/2, and Ethernet 1/3 are the member ports of the
aggregation group corresponding to Bridge-Aggregation 1.
Related commands
port link-type
port link-type
Use port link-type to configure the link type of a port.
Use undo port link-type to restore the default link type of a port.
Syntax
port link-type { access | hybrid | trunk }
undo port link-type
Default
Any port is an access port.
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
access: Configures the link type of a port as access.
hybrid: Configures the link type of a port as hybrid.
trunk: Configures the link type of a port as trunk.
Usage guidelines
The following matrix shows the command and router compatibility:
Command MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
port link-type
(Layer 2 aggregate
interface view)
No Yes No No Yes Yes Yes
To change the link type of a port from trunk to hybrid or vice versa, you must first set the link type to
access.
If an access port on an MSR1000 router is configured with the IP source guard binding feature, you
cannot configure the link type of this port as trunk or hybrid. For more information about IP source guard
binding, see "Configuring IP source guard."
The configuration made in Ethernet interface view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.