R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

35
port trunk pvid
Use port trunk pvid to configure the PVID for the trunk port.
Use undo port trunk pvid to restore the default.
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
Default
The PVID of a trunk port is VLAN 1.
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
The following matrix shows the command and router compatibility:
Command MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
port trunk pvid
(Layer 2 aggregate
interface view)
No Yes No No Yes Yes Yes
You can use a nonexistent VLAN as the PVID for a trunk port. If you use the undo vlan command to
remove the PVID of a trunk port, it does not affect the setting of the PVID on the port.
The local and remote trunk ports must use the same PVID for the traffic of the PVID to be transmitted
correctly.
You must use the port trunk permit vlan command to configure the trunk port to allow and forward
packets from the PVID.
The configuration made in Ethernet interface view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
• If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
Examples
# Configure VLAN 100 as the PVID of the trunk port Ethernet 1/1, and assign Ethernet 1/1 to VLAN
100.
<Sysname> system-view
[Sysname] interface ethernet 1/1