R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

72
Command MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
stp edged-port
(Layer 2 aggregate
interface view)
No Yes No No Yes Yes Yes
Examples
# Configure Ethernet 1/1 as an edge port.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] stp edged-port enable
Related commands
stp loop-protection
stp enable
Use stp enable to enable the spanning tree feature.
Use undo stp enable to disable the spanning tree feature.
Syntax
stp enable
undo stp enable
Default
The spanning tree feature is enabled on all ports and is globally disabled.
Views
System view, Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level
Usage guidelines
Configured in system view, the setting takes effect globally.
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
When you enable the spanning tree feature, the device operates in STP, RSTP, or MSTP mode, depending
on the spanning tree mode setting.
When you enable the spanning tree feature, the device dynamically maintains the spanning tree status
of VLANs based on received configuration BPDUs.
When you disable the spanning tree feature, the device stops maintaining the spanning tree status.
The following matrix shows the command and router compatibility: