R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

77
Default command level
2: System level
Usage guidelines
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
This feature takes effect only after you enable it on the root port.
The following matrix shows the command and router compatibility:
Command MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
stp
no-agreement-chec
k (Layer 2
aggregate interface
view)
No Yes No No Yes Yes Yes
Examples
# Enable No Agreement Check on Ethernet 1/1.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] stp no-agreement-check
stp pathcost-standard
Use stp pathcost-standard to specify a standard for the device to use when calculating the default path
costs for ports.
Use undo stp pathcost-standard to restore the default.
Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
Default
The default standard used by the device is legacy.
Views
System view
Default command level
2: System level
Parameters
dot1d-1998: Configures the device to calculate the default path cost for ports based on IEEE
802.1d-1998.
dot1t: Configures the device to calculate the default path cost for ports based on IEEE 802.1t.