R2511-HP MSR Router Series Layer 2 - LAN Switching Command Reference(V5)

92
Ethernet link aggregation configuration
commands
bandwidth
Use bandwidth to set the expected bandwidth for an aggregate interface or subinterface.
Use undo bandwidth to cancel the configuration.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
Layer 2 aggregate interface view, Layer 3 aggregate interface view, Layer 3 aggregate subinterface
view
Default command level
2: System level
Parameters
bandwidth-value: Specifies the expected bandwidth in the range of 1 to 4294967295 kbps.
Usage guidelines
You can get the expected bandwidth of an interface by querying the ifspeed value of the MIB node with
third-party software.
The expected bandwidth is used by network management systems for monitoring bandwidth, but does
not affect the actual bandwidth of the interface.
The following matrix shows the command and router compatibility in Layer 2 aggregate interface view:
Command MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
bandwidth No Yes No No Yes Yes Yes
Examples
# Set the expected bandwidth to 10,000 kbps for Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] bandwidth 10000
default
Use default to restore the default settings for an aggregate interface or subinterface.
Syntax
default