R2511-HP MSR Router Series Layer 2 - LAN Switching Configuration Guide(V5)

Configuration procedure

1. Configure Router A:

# Create VLAN 10, and assign the port Ethernet 1/4 to VLAN 10.

<RouterA> system-view

[RouterA] vlan 10

[RouterA-vlan10] port ethernet 1/4

[RouterA-vlan10] quit

# Create VLAN 20, and assign the port Ethernet 1/5 to VLAN 20.

[RouterA] vlan 20

[RouterA-vlan20] port ethernet 1/5

[RouterA-vlan20] quit

# Create Layer 2 aggregate interface Bridge-Aggregation 1, and configure the link aggregation

mode as dynamic.

[RouterA] interface bridge-aggregation 1

[RouterA-Bridge-Aggregation1] link-aggregation mode dynamic

# Assign ports Ethernet 1/1 through Ethernet 1/3 to link aggregation group 1 one at a time.

[RouterA] interface ethernet 1/1

[RouterA-Ethernet1/1] port link-aggregation group 1

[RouterA-Ethernet1/1] quit

[RouterA] interface ethernet 1/2

[RouterA-Ethernet1/2] port link-aggregation group 1

[RouterA-Ethernet1/2] quit

[RouterA] interface ethernet 1/3

[RouterA-Ethernet1/3] port link-aggregation group 1

[RouterA-Ethernet1/3] quit

# Configure Layer 2 aggregate interface Bridge-Aggregation 1 as a trunk port and assign it to

VLANs 10 and 20.

[RouterA] interface bridge-aggregation 1

[RouterA-Bridge-Aggregation1] port link-type trunk

[RouterA-Bridge-Aggregation1] port trunk permit vlan 10 20

Please wait... Done.

Configuring Ethernet1/1... Done.

Configuring Ethernet1/2... Done.

Configuring Ethernet1/3... Done.

[RouterA-Bridge-Aggregation1] quit

2. Configure Router B in the same way Router A is configured.

Verifying the configuration

# Display summary information about all aggregation groups on Router A.

[RouterA] display link-aggregation summary

Aggregation Interface Type:

BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation

Aggregation Mode: S -- Static, D -- Dynamic

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing

Actor System ID: 0x8000, 000f-e2ff-0001