R2511-HP MSR Router Series Layer 2 - LAN Switching Configuration Guide(V5)

105
[RouterB-Ethernet1/1] port trunk permit vlan all
# Enable GVRP on trunk port Ethernet 1/1.
[RouterB-Ethernet1/1] gvrp
[RouterB-Ethernet1/1] quit
# Create VLAN 3 (a static VLAN).
[RouterB] vlan 3
[RouterB-vlan3] quit
Verifying the configuration
Use the display gvrp local-vlan command to display the local VLAN information that GVRP maintains on
ports. For example:
# Display the local VLAN information that GVRP maintains on port Ethernet 1/1 of Router A.
[RouterA] display gvrp local-vlan interface ethernet 1/1
Following VLANs exist in GVRP local database:
1(default),2-3
The output shows that information about VLAN 1, static VLAN information about VLAN 2 on the local
router, and dynamic VLAN information about VLAN 3 on Router B are all registered through GVRP.
# Display the local VLAN information maintained by GVRP on port Ethernet 1/1 of Router B.
[RouterB] display gvrp local-vlan interface ethernet 1/1
Following VLANs exist in GVRP local database:
1(default),2-3
The output shows that information about VLAN 1, static VLAN information about VLAN 3 on the local
router, and dynamic VLAN information about VLAN 2 on Router A are all registered through GVRP.
GVRP fixed registration mode configuration example
Network requirements
As shown in Figure 34, enable GVRP and configure the fixed registration mode on ports to enable
registration and deregistration of static VLAN information between the two routers.
Figure 34 Network diagram
Configuration procedure
1. Configure Router A:
# Enable GVRP globally.
<RouterA> system-view
[RouterA] gvrp
# Configure port Ethernet 1/1 as a trunk port, and assign it to all VLANs.
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] port link-type trunk
[RouterA-Ethernet1/1] port trunk permit vlan all
# Enable GVRP on Ethernet 1/1 and set the GVRP registration mode to fixed on the port.