R2511-HP MSR Router Series Layer 2 - LAN Switching Configuration Guide(V5)

131
{ Configure Host A's IP address as 1.1.1.1/8, and gateway IP address as 1.0.0.1/8.
{ Configure Host B's IP address as 2.2.2.2/8, and gateway IP address as 2.0.0.1/8.
{ Configure Host C's IP address as 3.3.3.3/8, and gateway IP address as 3.0.0.1/8.
{ Configure Host D's IP address as 4.4.4.4/8, and gateway IP address as 4.0.0.1/8.
2. Configure Layer 2 Switch A:
# Assign Ethernet 1/2 to VLAN 10.
<L2_SwitchA> system-view
[L2_SwitchA] vlan 10
[L2_SwitchA-vlan10] port ethernet 1/2
[L2_SwitchA-vlan10] quit
# Assign Ethernet 1/3 to VLAN 20.
[L2_SwitchA] vlan 20
[L2_SwitchA-vlan20] port ethernet 1/3
[L2_SwitchA-vlan20] quit
# Configure Ethernet 1/1 as a trunk port, and assign it to VLAN 10 and VLAN 20.
[L2_SwitchA] interface ethernet 1/1
[L2_SwitchA-Ethernet1/1] port link-type trunk
[L2_SwitchA-Ethernet1/1] port trunk permit vlan 10 20
3. Configure Layer 2 Switch B in the same way Layer 2 Switch A is configured.
4. Configure the router:
# Create Ethernet 1/1.10, Ethernet 1/1.20, Ethernet 2/1.10, and Ethernet 2/1.20, and then
assign IP addresses to them. Configure Ethernet 1/1.10 and Ethernet 2/1.10 to terminate packets
tagged with VLAN 10, and configure Ethernet 1/1.20 and Ethernet 2/1.20 to terminate packets
tagged with VLAN 20.
<Router> system-view
[Router] interface ethernet 1/1.10
[Router-Ethernet1/1.10] ip address 1.0.0.1 255.0.0.0
[Router-Ethernet1/1.10] vlan-type dot1q vid 10
[Router-Ethernet1/1.10] quit
[Router] interface ethernet 1/1.20
[Router-Ethernet1/1.20] ip address 2.0.0.1 255.0.0.0
[Router-Ethernet1/1.20] vlan-type dot1q vid 20
[Router-Ethernet1/1.20] quit
[Router] interface ethernet 2/1.10
[Router-Ethernet2/1.10] ip address 3.0.0.1 255.0.0.0
[Router-Ethernet2/1.10] vlan-type dot1q vid 10
[Router-Ethernet2/1.10] quit
[Router] interface ethernet 2/1.20
[Router-Ethernet2/1.20] ip address 4.0.0.1 255.0.0.0
[Router-Ethernet2/1.20] vlan-type dot1q vid 20
[Router-Ethernet2/1.20] quit