R2511-HP MSR Router Series Layer 2 - LAN Switching Configuration Guide(V5)

15
Ste
p
Command Remarks
2. Enter interface view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• The configuration made in Layer 2
Ethernet interface view applies only to the
port.
• The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
3. Configure the link type of
the ports as access.
port link-type access
Optional.
By default, all ports are access ports.
4. Assign the access ports
to a VLAN.
port access vlan vlan-id
Optional.
By default, all access ports belong to VLAN
1.
Assigning a trunk port to a VLAN
A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view.
Only MSR93X, MSR30, MSR50, and MSR1000 routers support Layer 2 aggregate interfaces.
To assign a trunk port to one or multiple VLANs:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• The configuration made in Layer 2
Ethernet interface view applies only to the
port.
• The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
3. Configure the link type of
the ports as trunk.
port link-type trunk By default, all ports are access ports.
4. Assign the trunk ports to
the specified VLANs.
port trunk permit vlan
{ vlan-list | all }
By default, a trunk port carries only VLAN 1.